# Inductor

## Our Take

An inductor is a device created specifically for its inductive properties. Their capacity is measured in henries, which is when a change of one amp per second yields a voltage differential of one volt across the device. Real, or non-ideal, inductors have a small amount of capacitance and resistance as well but those properties can arguably be ignored most of the time. However, if your circuit isn’t responding the way you anticipated, those may not be so negligible. Inductors are typically used to absorb high frequency signals or adjust the resonant frequency of a circuit.

## Book Definition

It consists of a coil of conducting wire.

Fundamentals of Electric Circuits, 5th Edition by Charles K. Alexander and Matthew N. O. Sadiku

Coil of wire with inductance.

Grob’s Basic Electronics, 11th Edition by Mitchel E. Schultz

## Wikipedia

An inductor, also called a coil, choke, or reactor, is a passive two-terminal electrical component that stores energy in a magnetic field when electric current flows through it.[1] An inductor typically consists of an insulated wire wound into a coil around a core.

When the current flowing through an inductor changes, the time-varying magnetic field induces an electromotive force (e.m.f.) (voltage) in the conductor, described by Faraday's law of induction. According to Lenz's law, the induced voltage has a polarity (direction) which opposes the change in current that created it. As a result, inductors oppose any changes in current through them.

An inductor is characterized by its inductance, which is the ratio of the voltage to the rate of change of current. In the International System of Units (SI), the unit of inductance is the henry (H) named for 19th century American scientist Joseph Henry. In the measurement of magnetic circuits, it is equivalent to weber/ampere. Inductors have values that typically range from 1 µH (10−6 H) to 20 H. Many inductors have a magnetic core made of iron or ferrite inside the coil, which serves to increase the magnetic field and thus the inductance. Along with capacitors and resistors, inductors are one of the three passive linear circuit elements that make up electronic circuits. Inductors are widely used in alternating current (AC) electronic equipment, particularly in radio equipment. They are used to block AC while allowing DC to pass; inductors designed for this purpose are called chokes. They are also used in electronic filters to separate signals of different frequencies, and in combination with capacitors to make tuned circuits, used to tune radio and TV receivers.

Get the latest tools and tutorials, fresh from the toaster.