Plane Electromagnetic Waves

By the end of this section, you will be able to:

• Describe how Maxwell’s equations predict the relative directions of the electric fields and magnetic fields, and the direction of propagation of plane electromagnetic waves
• Explain how Maxwell’s equations predict that the speed of propagation of electromagnetic waves in free space is exactly the speed of light
• Calculate the relative magnitude of the electric and magnetic fields in an electromagnetic plane wave
• Describe how electromagnetic waves are produced and detected

Mechanical waves travel through a medium such as a string, water, or air. Perhaps the most significant prediction of Maxwell’s equations is the existence of combined electric and magnetic (or electromagnetic) fields that propagate through space as electromagnetic waves. Because Maxwell’s equations hold in free space, the predicted electromagnetic waves, unlike mechanical waves, do not require a medium for their propagation.

A general treatment of the physics of electromagnetic waves is beyond the scope of this textbook. We can, however, investigate the special case of an electromagnetic wave that propagates through free space along the

-axis of a given coordinate system.

An electromagnetic wave consists of an electric field, defined as usual in terms of the force per charge on a stationary charge, and a magnetic field, defined in terms of the force per charge on a moving charge. The electromagnetic field is assumed to be a function of only the

-coordinate and time. The

-component of the electric field is then written as

the

-component of the magnetic field as

etc. Because we are assuming free space, there are no free charges or currents, so we can set

and

in Maxwell’s equations.

The transverse nature of electromagnetic waves

We examine first what Gauss’s law for electric fields implies about the relative directions of the electric field and the propagation direction in an electromagnetic wave. Assume the Gaussian surface to be the surface of a rectangular box whose cross-section is a square of side

and whose third side has length

as shown in Figure 13.2.1. Because the electric field is a function only of

and

the

-component of the electric field is the same on both the top (labeled Side 2) and bottom (labeled Side 1) of the box, so that these two contributions to the flux cancel. The corresponding argument also holds for the net flux from the

-component of the electric field through Sides 3 and 4. Any net flux through the surface therefore comes entirely from the

-component of the electric field. Because the electric field has no

or

-dependence,

is constant over the face of the box with area

and has a possibly different value

that is constant over the opposite face of the box. Applying Gauss’s law gives

(13.2.1)

where

is the area of the front and back faces of the rectangular surface. But the charge enclosed is

so this component’s net flux is also zero, and Equation 13.2.1 implies

for any

Therefore, if there is an

-component of the electric field, it cannot vary with

A uniform field of that kind would merely be superposed artificially on the traveling wave, for example, by having a pair of parallel-charged plates. Such a component

would not be part of an electromagnetic wave propagating along the

-axis; so

for this wave. Therefore, the only nonzero components of the electric field are

and

perpendicular to the direction of propagation of the wave.

(Figure 13.2.1)

A similar argument holds by substituting

for

and using Gauss’s law for magnetism instead of Gauss’s law for electric fields. This shows that the

field is also perpendicular to the direction of propagation of the wave. The electromagnetic wave is therefore a transverse wave, with its oscillating electric and magnetic fields perpendicular to its direction of propagation.

The speed of propagation of electromagnetic waves

We can next apply Maxwell’s equations to the description given in connection with Figure 13.1.3 in the previous section to obtain an equation for the

field from the changing

field, and for the

field from a changing

field. We then combine the two equations to show how the changing

and

fields propagate through space at a speed precisely equal to the speed of light.First, we apply Faraday’s law over Side 3 of the Gaussian surface, using the path shown in Figure 13.2.2. Because

we have

Assuming

is small and approximating

by

we obtain

(Figure 13.2.2)

Because

is small, the magnetic flux through the face can be approximated by its value in the centre of the area traversed, namely

The flux of the

field through Face 3 is then the

field times the area,

(13.2.2)

From Faraday’s law,

(13.2.3)

Therefore, from Equation 13.2.1 and Equation 13.2.2,

Canceling

and taking the limit as

we are left with

(13.2.4)

We could have applied Faraday’s law instead to the top surface (numbered 2) in Figure 13.2.2, to obtain the resulting equation

(13.2.5)

This is the equation describing the spatially dependent

field produced by the time-dependent

field.

Next we apply the Ampère-Maxwell law (with

) over the same two faces (Surface 3 and then Surface 2) of the rectangular box of Figure 13.2.2. Applying Equation 13.1.10,

to Surface 3, and then to Surface 2, yields the two equations

(13.2.6)

(13.2.7)

These equations describe the spatially dependent

field produced by the time-dependent

field.We next combine the equations showing the changing

field producing an

field with the equation showing the changing

field producing a

field. Taking the derivative of Equation 13.2.4 with respect to

and using Equation 13.2.14 gives

or

(13.2.8)

This is the form taken by the general wave equation for our plane wave. Because the equations describe a wave traveling at some as-yet-unspecified speed

we can assume the field components are each functions of

for the wave traveling in the

-direction, that is,

(13.2.9)

It is left as a mathematical exercise to show, using the chain rule for differentiation, that Equation 13.2.5 and Equation 13.2.6 imply

The speed of the electromagnetic wave in free space is therefore given in terms of the permeability and the permittivity of free space by

(13.2.10)

We could just as easily have assumed an electromagnetic wave with field components

and

The same type of analysis with Equation 13.2.13 and Equation 13.2.12 would also show that the speed of an electromagnetic wave is

The physics of traveling electromagnetic fields was worked out by Maxwell in 1873. He showed in a more general way than our derivation that electromagnetic waves always travel in free space with a speed given by Equation 13.2.6. If we evaluate the speed

we find that

which is the speed of light. Imagine the excitement that Maxwell must have felt when he discovered this equation! He had found a fundamental connection between two seemingly unrelated phenomena: electromagnetic fields and light.

The wave equation was obtained by (1) finding the

field produced by the changing

field, (2) finding the

field produced by the changing

field, and combining the two results. Which of Maxwell’s equations was the basis of step (1) and which of step (2)?

How the E and B Fields Are Related

So far, we have seen that the rates of change of different components of the

and

fields are related, that the electromagnetic wave is transverse, and that the wave propagates at speed

We next show what Maxwell’s equations imply about the ratio of the

and

field magnitudes and the relative directions of the

and

fields.

We now consider solutions to Equation 13.2.4 in the form of plane waves for the electric field:

(13.2.11)

We have arbitrarily taken the wave to be traveling in the

-direction and chosen its phase so that the maximum field strength occurs at the origin at time

We are justified in considering only sines and cosines in this way, and generalizing the results, because Fourier’s theorem implies we can express any wave, including even square step functions, as a superposition of sines and cosines.

At any one specific point in space, the

field oscillates sinusoidally at angular frequency

between

and

and similarly, the

field oscillates between

and

The amplitude of the wave is the maximum value of

The period of oscillation

is the time required for a complete oscillation. The frequency f is the number of complete oscillations per unit of time, and is related to the angular frequency

by

The wavelength

is the distance covered by one complete cycle of the wave, and the wavenumber

is the number of wavelengths that fit into a distance of

in the units being used. These quantities are related in the same way as for a mechanical wave:

Given that the solution of

has the form shown in Equation 13.2.8, we need to determine the

field that accompanies it. From Equation 13.2.12, the magnetic field component

must obey

(13.2.1)

Because the solution for the

-field pattern of the wave propagates in the

-direction at the same speed

as the

-field pattern, it must be a function of

Thus, we conclude from Equation 13.2.9 that

is

These results may be written as

(13.2.13)

(13.2.14)

Therefore, the peaks of the

and

fields coincide, as do the troughs of the wave, and at each point, the

and

fields are in the same ratio equal to the speed of light

The plane wave has the form shown in Figure 13.2.3.

Calculating B-Field Strength in an Electromagnetic Wave

What is the maximum strength of the

field in an electromagnetic wave that has a maximum

-field strength of

?

Strategy

To find the

-field strength, we rearrange Equation 13.2.11 to solve for

yielding

Solution

We are given

and

is the speed of light. Entering these into the expression for

yields

Significance

The

-field strength is less than a tenth of Earth’s admittedly weak magnetic field. This means that a relatively strong electric field of

is accompanied by a relatively weak magnetic field.

Changing electric fields create relatively weak magnetic fields. The combined electric and magnetic fields can be detected in electromagnetic waves, however, by taking advantage of the phenomenon of resonance, as Hertz did. A system with the same natural frequency as the electromagnetic wave can be made to oscillate. All radio and TV receivers use this principle to pick up and then amplify weak electromagnetic waves, while rejecting all others not at their resonant frequency.

What conclusions did our analysis of Maxwell’s equations lead to about these properties of a plane electromagnetic wave:

(a) the relative directions of wave propagation, of the

field, and of

field,

(b) the speed of travel of the wave and how the speed depends on frequency, and

(c) the relative magnitudes of the

and

fields.

Production and Detection of Electromagnetic Waves

A steady electric current produces a magnetic field that is constant in time and which does not propagate as a wave. Accelerating charges, however, produce electromagnetic waves. An electric charge oscillating up and down, or an alternating current or flow of charge in a conductor, emit radiation at the frequencies of their oscillations. The electromagnetic field of a dipole antenna is shown in Figure 13.2.4. The positive and negative charges on the two conductors are made to reverse at the desired frequency by the output of a transmitter as the power source. The continually changing current accelerates charge in the antenna, and this results in an oscillating electric field a distance away from the antenna. The changing electric fields produce changing magnetic fields that in turn produce changing electric fields, which thereby propagate as electromagnetic waves. The frequency of this radiation is the same as the frequency of the ac source that is accelerating the electrons in the antenna. The two conducting elements of the dipole antenna are commonly straight wires. The total length of the two wires is typically about one-half of the desired wavelength (hence, the alternative name half-wave antenna), because this allows standing waves to be set up and enhances the effectiveness of the radiation.

(Figure 13.2.4)

The electric field lines in one plane are shown. The magnetic field is perpendicular to this plane. This radiation field has cylindrical symmetry around the axis of the dipole. Field lines near the dipole are not shown. The pattern is not at all uniform in all directions. The strongest signal is in directions perpendicular to the axis of the antenna, which would be horizontal if the antenna is mounted vertically. There is zero intensity along the axis of the antenna. The fields detected far from the antenna are from the changing electric and magnetic fields inducing each other and traveling as electromagnetic waves. Far from the antenna, the wave fronts, or surfaces of equal phase for the electromagnetic wave, are almost spherical. Even farther from the antenna, the radiation propagates like electromagnetic plane waves.

The electromagnetic waves carry energy away from their source, similar to a sound wave carrying energy away from a standing wave on a guitar string. An antenna for receiving electromagnetic signals works in reverse. Incoming electromagnetic waves induce oscillating currents in the antenna, each at its own frequency. The radio receiver includes a tuner circuit, whose resonant frequency can be adjusted. The tuner responds strongly to the desired frequency but not others, allowing the user to tune to the desired broadcast. Electrical components amplify the signal formed by the moving electrons. The signal is then converted into an audio and/or video format.

Use this simulation to broadcast radio waves. Wiggle the transmitter electron manually or have it oscillate automatically. Display the field as a curve or vectors. The strip chart shows the electron positions at the transmitter and at the receiver.

CC licensed content, Specific attribution

• Download for free at http://cnx.org/contents/7a0f9770-1c44-4acd-9920-1cd9a99f2a1e@8.1. Retrieved from: http://cnx.org/contents/7a0f9770-1c44-4acd-9920-1cd9a99f2a1e@8.1. License: CC BY: Attribution